ITALIAN VERSION (English below) ISTRUZIONI DI INSTALLAZIONE DELL'AGGIORNAMENTO DEL FIRMWARE PMM 9010: 1) I files sono compressi per velocizzare il trasferimento. Per decomprimerli è necessaria un'utility di decompressione. Le utility di decompressione, per differenti sistemi operativi possono essere scaricate dal nostro sito: http://www.narda-sts.it/ 2) Dopo aver decompresso il file scaricato posizionarsi sulla directory scelta e lanciare il programma SETUP.EXE per installare l'aggiornamento 3) Seguire le istruzioni riportate sul Manuale Operativo NOTE FIRMWARE: n1) Il FW del 9010F è completamente diverso da quello degli altri ricevitori della Serie 9010, per cui si deve evitare l'installazione di qualsiasi altro FW diverso da quello contenuto in questa sezione. n2) Per abilitare il controllo dei Moduli RF 9030/9060/9180 da parte del 9010F è necessario aggiornare anche il FW di ciascuno di questi moduli, facendo riferimento alla relativa sezione di "Download". ----------------------------------------------------------------------------------------------- ENGLISH VERSION PMM 9010 FIRMWARE UPDATE INSTALLATION INSTRUCTIONS: 1) The files are ZIP-compressed for faster downloading. To unzip them you need a software compression utility. The unzipping utilities for different operating systems can be downloaded from our site: http://www.narda-sts.it/ 2) After decompression to install the software update move to the destination directory and run the file SETUP.EXE 3) Follow the installation instructions and use on the Operating Manual IMPORTANT FIRMWARE NOTES: n1) FW of 9010F is completely different from any other FW issued for others 9010 Series receivers, therefore be sure tonot attempt installation of a FW release different from the one contained in this section. n2) To enable proper control of RF Modules 9030/9060/9180 by 9010F you must proceed in updating FW of each module after downloading related FW release available in separate specific section.